You can use GhostCast to restore the image, restore the image locally from an external hard drive that is attached to the model computer, or restore the image from a network share. Then use Ghost to restore the recovery environment you created in step 5 above. Use Ghost to perform a partition restore operation of the disk image you captured in step 1 above.
#How to use symantec ghost 32 install
If the internal hard drive you wish to install the Recovery Kit on is not disk 0, adjust the command lines accordingly:ĭelete partition (continue this untill all partitions are deleted)Ĭreate partition primary size=100 (This value should not vary)Ĭreate partition primary size=50000 (This value can vary depending on how large the OS partition should be)ġ0. Note: This example assumes that disk 0 is the internal hard drive that you will be modifying.
#How to use symantec ghost 32 windows 7
When you quit Ghost, you'll be taken to a command prompt, where you can use Diskpart to create the required partitions for Windows 7 and for the recovery environment. When Ghost opens, click OK to the welcome message and then choose the option to Quit Ghost.ĩ. Boot your model computer with the boot package you just created.Ĩ. Do not include any modifications to the start.bat file.ħ. Once you have captured the image of the boot package that contains the start.bat modifications listed above, go back to the Ghost Boot Wizard again and create a new Windows PE boot package. This image will become the recovery partition that your backup image will be restored from.Ħ. This can be done from Windows on the computer that has the Ghost tools installed. Once the flash drive has been successfully written, use ghost32.exe to capture an image of it. When the modifications are complete, click Stop Editing and then complete the wizardĥ. Ghost32.exe -clone,mode=prestore,src=1:3\image\image.gho:2,dst=1:2 -quiet -sure -rbĤ.
Ghost32.exe -clone,mode=prestore,src=1:3\image\image.gho:1,dst=1:1 -quiet -sure Ghost32.exe /setosdrives /blind>x:\ghost\startlog.txt Rem - This will create the primary OS drive configuration When you reach the "Review" screen in the Ghost Boot Wizard, click the Start Editing button and alter the start.bat file so that it reads as follows: Step by step directions for accomplishing this are located in the Supplemental materials below.ģ. Create a Windows PE USB flash drive using the Ghost Boot Wizard. For the purpose of this document, the image filename should be image.ghoĢ.
Set up a model computer with all of the customizations you want included on your recovery image. Neither of these requirements are addressed within the scope of this document.ġ. OEM manufacturers are also required by Symantec to use ghostoem32.exe to perform the restoration of the image file. For OEM manufacturers, Microsoft requires you to lock the image to the BIOS and/or hardware. Note: This procedure is not appropriate for OEM manufacturers that want to use the Ghost Recovery Kit.
0 kommentar(er)
